1吨中频炉说明之英语好声音(共4页).doc

《1吨中频炉说明之英语好声音(共4页).doc》由会员分享，可在线阅读，更多相关《1吨中频炉说明之英语好声音(共4页).doc（4页珍藏版）》请在淘文阁 - 分享文档赚钱的网站上搜索。

1、精选优质文档-倾情为你奉上1吨中频炉说明之英语好声音1-ton intermediate frequency furnace由或配1吨中频感应加热炉两台用于铸钢熔炼。KGPS intermediate frequency power source or 12 pulse frequency power source supplied with two 1-ton intermediate frequency induction heating furnace for steel melting .一、技术参数设备配置设备型号GWT-1/750技术指标（6脉）技术指标（12脉）设备额定功率750

2、KW 750KW进相电压3*660V6*660V电炉额定电压2800V2800V额定容量1T1T额定温度16001600配电源规格KGPS-1/750KGPS-1/750单套价格成套配置单：快速一套补偿电容柜一套中频炉二台减速机二台水冷电缆两根坩埚膜一只说明书资料一份维修保修期1年备注：1）用6相。消除了5、7高次谐波，大大减少了电网的谐波干扰。2）采用全封闭式冷却塔提可提高系统的冷却效果和设备的使用寿命，无须建水池。ModelGWT-1/750Index（6 pulse）Index（12 pulse）技术指标（12脉）Rated power750KW750KW 750KWPhase volt

3、age3*660V3*660V6*660VRated voltage2800V2800V2800VRated capacity1T1T1TRated temperature160016001600Power specificationsKGPS-1/750KGPS-1/750KGPS-1/750Single set priceComplete configuration：Fast 12 pulse intermediate frequency power sourceA setCompensation capacitorA setIntermediate frequency furnaceTw

4、oReducerTwoWater cooled cablesTwoCrucible filmOneInstructions for useOneWarranty period1 year1）6 phase 12 pulse intermediate frequency power source control system can eliminate 5, 7high-order harmonic，and significantly reduces the power grid harmonic interference。2）Closed circuit cooling tower is us

5、ed to improve the effect of the cooling system and equipment service life，without building the pool.二、水冷设备：可以在生产现场筑水池，通过水泵使水循环对设备进行冷却，也可选用整套组合型冷却设备。炉体和电源分别采用两套独立（也可采用一套）的全封闭冷却装置。采用相互独立的二套冷却装置的目的是为了避免相互影响。冷却塔的下面有集水盘，内装喷淋用水，集水盘的进水口装有浮球阀，能够自动控制集水盘内的水位，出水口有喷淋水泵。因为中频电源需要低温的冷却水，出水温度要控制在55以内，由于电炉感应线圈的冷却水温度

6、略高，这样反而能够提高电炉的热效率，同时减小冷却装置的体积，进而减低造价。全封闭冷却装置的核心是喷淋蒸发式封闭冷却塔。在冷却塔内部有许多散热盘管，循环水在盘管内部流动，与空气不接触。冷却塔的上部装有喷水口和冷却风机。工作时喷淋水泵将水泵到上部的喷水口，将水呈雾状喷淋到盘管外表面，冷却风机同时抽风，使喷淋水汽化从而带走盘管内循环水的热量。这种先进型式的冷却装置具有很高的换热效率。建议采用FSS-200封闭式循环冷却塔，能大量节约生产场地占地面积。Water cooler: (optional)Builting pools in the production site to cool water

7、through the pump cycles on the devices, or choosing the package combination of cooling equipment. Furnace and power source respectively adopt a set of fully closed cooling device ( or a set together ). Using two sets of cooling device in order to avoid interaction. Water collecting tray under the co

8、oling tower, built-in spray water, is equipped with a float ball valve in its inlet, can automatically control the water level of a water collecting tray, and its outlet also has a spray pump. The intermediate frequency power source need low temperature cooling water, outlet water temperature should

9、 be controlled at 55 C or less, the electric induction coil cooling water temperature is slightly higher, so it can improve the heat efficiency of the furnace, while reducing the volume of cooling device, and reduce the cost. Core of the fully closed cooling device is spray evaporative closed coolin

10、g tower. There are a lot of radiating coil in the cooling tower, circulating water flow in the coil, so it is isolated from the air. The upper part is provided with a water outlet of cooling tower and cooling fan. When working, the spray pumps water to the upper part of the spout, the water mist spr

11、ay onto the surface of the coil, at the same time, cooling fan exhausting to vaporize spray water, carry off circulating water heat inside the coil.The advanced method of cooling device has high heat exchange efficiency. FSS-200 closed circulating cooling tower is recommended, which can save large p

12、roduction sites.循环水冷却设备技术参数如下表：设备型号FSS-200冷却能力（kcal/h）工作流量（m3/h）18-35工作水压（Mpa）0.2进出水管口径DN50额定功率主水泵（KW）2.2风机（KW）0.55*2喷淋泵（KW）0.75电源（V）380主机外形尺寸（mm）1800*1300*1200空机重量（kg）600Circulating water cooling equipment technical parameters ModelFSS-200Cooling capacity（kcal/h）Working flow（m3/h）18-35Working press

13、ure（Mpa）0.2Pipe diameterDN50Rated powerMain pump（KW）2.2cooling fan（KW）0.55*2Spray pump（KW）0.75Power source（V）380HostSize（mm）1800*1300*1200Empty weight（kg）600四、设备简介：1、电源采用并联谐振电路，控制电路完全集成化，中频电源采用零电压软起动。操作十分方便，稳定可靠，无故障时间长，检修方便，维修费用低。2、有过压、过流、缺相、欠压、欠水压，冷却水温超限报警保护等多项功能，安全可靠。3、在合适的功率下稳定运行，熔化速度快，生产效率高。4、采用

14、三相全桥整流，高次谐波小，对电网无干扰，同时变压器不发热，损耗极低。5、电源工作时节约电能，节水，体积小，重量轻，使用安全，使用范围广泛。Introduction1. Power source adopts a parallel resonant circuit, the control circuit is fully integrated, intermediate frequency power source zero voltage soft start. Convenient operation and maintenance, stable,reliable, low repair

15、 cost.2. Intermediatefrequency power source has many function, including overvoltage, overcurrent, lack-phase, under-voltage, lack of water, cooling water temperature overrun alarm protection ,its safe and reliable.3. Melting fast and high production efficiency when Stable power and stable operation

16、. 4. Three-phase full-bridge rectifier, small hign-order harmonics, without interference on power grid, the transformer does not heat and low loss.5. When power source works, electric and water is saved. Small volume, light weight, safty, wide used ,.五、加热特点：1、熔炼工艺稳定，铸件有较高的机械强度；2、氧化损耗少，可实现无氧化熔炼，减少熔化损

17、耗；3、铁液中自身存在电磁搅拌作用，金属成分均匀，可熔炼各种加工切屑和细小的边角料，降低成本；4、减少环境污染；5、功率密度大，熔化速度快，起熔方便；6、操作使用灵活方便，频率可选择；7、土建费用小；8、精湛的线圈设计，优质的厚壁铜管，通过合理选择感应圈的匝间距离使得感应圈的转换效率最高，电阻最小，更多的能量可用于熔炼、加热，强度高，线圈不易发生因电弧和膨胀力引起损坏。 Heating characteristics1. Intermediate frequency furnace smelting process is stable, the castings have high mecha

18、nical strength2. Oxidation loss, no oxidation melting, reduction of the melting loss3. Liquid iron have electromagnetic stirring itself and homogeneous metal components, can smelt any chip and small scrap, reducing cost4. Reduce environmental pollution5. High power density, fast melting, start melti

19、ng conveniently6. Flexible and convenient operation, selected frequency 7. Low construction costs8. Superb coil design, high quality thick-walled copper tubes , Rational selection of induction loop interturn distance makes the highest conversion efficiency of induction coil ,resistance minimum,so more energy can be used for melting, heating, high strength, coils are prone to damage due to arc and expansive fo rce. 作者:康忠波 专心-专注-专业