计算机网络(简答整理).doc

《计算机网络(简答整理).doc》由会员分享，可在线阅读，更多相关《计算机网络(简答整理).doc（19页珍藏版）》请在淘文阁 - 分享文档赚钱的网站上搜索。

1、Four short words sum up what has lifted most successful individuals above the crowd: a little bit more.-author-date计算机网络(简答整理)第一章 习题5. A factor in the delay of a store-and-forward packet-switching system is how long it takes to store and forward a packet through a switch. If switching time is 10 sec

2、, is this likely to be a major factor in the response of a client-server system where the client is in New York and the server is in California? Assume the propagation speed in copper and fiber to be 2/3 the speed of light in vacuum.Solution：5. No. The speed of propagation is 200,000 km/sec or 200 m

3、eters/sec. In 10sec the signal travels 2 km. Thus, each switch adds the equivalent of 2 km of extra cable. If the client and server are separated by 5000 km, traversing even 50 switches adds only 100 km to the total path, which is only 2%. Thus, switching delay is not a major factor under these circ

4、umstances.13. What is the principal difference between connectionless communication and connection-oriented communication?Solution：13. Connection-oriented communication has three phases. In the establishment phase a request is made to set up a connection. Only after this phase has been successfully

5、completed can the data transfer phase be started and data transported. Then comes the release phase. Connectionless communication does not have these phases. It just sends the data.18. Which of the OSI layers handles each of the following:a. Dividing the transmitted bit stream into frames.b. Determi

6、ning which route through the subnet to use.Solution：18. (a) Data link layer. (b) Network layer.21. List two ways in which the OSI reference model and the TCP/IP reference model are the same. Now list two ways in which they differ.Solution：21. Both models are based on layered protocols. Both have a n

7、etwork, transport, and application layer. In both models, the transport service can provide a reliable end-to-end byte stream. On the other hand, they differ in several ways. The number of layers is different, the TCP/IP does not have session or presentation layers, OSI does not support internetwork

8、ing, and OSI has both connection-oriented and connectionless service in the network layer.22. What is the main difference between TCP and UDP?Solution：22. TCP is connection oriented, whereas UDP is a connectionless service.26. Why does ATM use small, fixed-length cells?Solution：26. Small, fixed-leng

9、th cells can be routed through switches quickly, and completely in hardware. Small, fixed-size cells also make it easier to build hardware that handles many cells in parallel. Also, they do not block transmission lines for very long, making it easier to provide quality-of-service guarantees.6. What

10、is the difference between a passive star and an active repeater in a fiber network?Solution：6. A passive star has no electronics. The light from one fiber illuminates anumber of others. An active repeater converts the optical signal to an electricalone for further processing.9. Is the Nyquist theore

11、m true for optical fiber or only for copper wire?Solution：9. The Nyquist theorem is a property of mathematics and has nothing to do with technology. It says that if you have a function whose Fourier spectrum does not contain any sines or cosines above f, then by sampling the function at a frequency

12、of 2f you capture all the information there is. Thus, the Nyquist theorem is true for all media.29. Why has the PCM sampling time been set at 125 sec?Solution：29. A sampling time of 125 sec corresponds to 8000 samples per second. According to the Nyquist theorem, this is the sampling frequency neede

13、d to capture all the information in a 4 kHz channel, such as a telephone channel.(Actually the nominal bandwidth is somewhat less, but the cutoff is not sharp.)22. An IP packet to be transmitted by Ethernet is 60 bytes long, including all its headers. If LLC is not in use, is padding needed in the E

14、thernet frame, and if so, how many bytes?Solution:22. The minimum Ethernet frame is 64 bytes, including both addresses in the Ethernet frame header, the type/length field, and the checksum. Since the header fields occupy 18 bytes and the packet is 60 bytes, the total frame size is 78 bytes, which ex

15、ceeds the 64-byte minimum. Therefore, no padding is used.24. Some books quote the maximum size of an Ethernet frame as 1518 bytes instead of 1500 bytes. Are they wrong? Explain your answer.Solution:The payload is 1500 bytes, but when the destination address, source address, type/length, and checksum

16、 fields are counted too, the total is indeed 1518.42Briefly describe the difference between store-and-forward and cut-through switches.Solution:A store-and-forward switch stores each incoming frame in its entirety, then examines it and forwards it. A cut-through switch starts to forward incoming fra

17、mes before they have arrived completely. As soon as the destination address is in, the forwarding can begin.43Store-and-forward switches have an advantage over cut-through switches with respect to damaged frames. Explain what it is.Solution:43. Store-and-forward switches store entire frames before f

18、orwarding them. After a frame comes in, the checksum can be verified. If the frame is damaged, it is discarded immediately. With cut=through, damaged frames cannot be discarded by the switch because by the time the error is detected, the frame is already gone. Trying to deal with the problem is like

19、 locking the barn door after the horse has escaped.45In Fig. 4-50 the switch in the legacy end domain on the right is a VLAN-aware switch. Would it be possible to use a legacy switch there? If so, how would that work? If not, why not?Solution:45. It would work. Frames entering the core domain would

20、all be legacy frames, so it would be up to the first core switch to tag them. It could do this by using MAC addresses or IP addresses. Similarly, on the way out, that switch would have to untag outgoing frames.42. The set of IP addresses from 29.18.0.0 to 19.18.128.255 has been aggregated to 29.18.0

21、.0/17. However, there is a gap of 1024 unassigned addresses from 29.18.60.0 to 29.18.63.255 that are now suddenly assigned to a host using a different outgoing line. Is it now necessary to split up the aggregate address into its constituent blocks, add the new block to the table, and then see if any

22、 reaggregation is possible? If not, what can be done instead?Solution:It is sufficient to add one new table entry: 29.18.0.0/22 for the new block. If an incoming packet matches both 29.18.0.0/17 and 29.18.0.0./22, the longest one wins. This rule makes it possible to assign a large block to one outgo

23、ing line but make an exception for one or more small blocks within its range.27. Give one reason why a firewall might be configured to inspect incoming traffic. Give one reason why it might be configured to inspect outgoing traffic. Do you think the inspections are likely to be successful?SolutionIn

24、coming traffic might be inspected for the presence of viruses. Outgoing traffic might be inspected to see if company confidential information is leaking out. Checking for viruses might work if a good antivirus program is used. Checking outgoing traffic, which might be encrypted, is nearly hopeless a

25、gainst a serious attempt to leak information.29. Suppose an organization uses VPN to securely connect its sites over the Internet. Is there a need for a user, Jim, in this organization to use encryption or any other security mechanism to communicate with another user Mary in the organization.Solutio

26、nIf Jim does not want to reveal who he is communicating with to anyone (including his own system administrator, then Jim needs to use additional security mechanisms. Remember that VPN provides security for communication only over the Internet (outside the organization). It does not provide any security for communication inside the organization. If Jim only wants to keep his communication secure from people outside the company, a VPN is sufficient.-