用“如果…又怎样”的问题去用于教科学-毕业论文外文翻译.docx

《用“如果…又怎样”的问题去用于教科学-毕业论文外文翻译.docx》由会员分享，可在线阅读，更多相关《用“如果…又怎样”的问题去用于教科学-毕业论文外文翻译.docx（21页珍藏版）》请在淘文阁 - 分享文档赚钱的网站上搜索。

1、原文题目：Using “What if.” questions to teach science AbstractWith the widening knowledge base students will need to be more flexible in their learning habits. Traditionally, teaching school science often involves teacher-centred methods like lectures, experimental demonstration or guided inquiry. Plain

2、knowledge dissemination will not adequately prepare students to cope with the changing world. Hence, schools need to train students to be reflective in their learning habits that is, getting students to be observant, to generate relevant alternatives and to make sense of these ideas. This article di

3、scusses a well-documented reflective learning strategy - the use of “what if” questions, to help students extend their learning beyond curricular requirements. Students are introduced to a distillation set up and then asked to pose “what if” questions about it. Their questions and the corresponding

4、peer responses are a wealth of information for teachers to explore how science may be taught differently and with a greater impact on their students learning experience.IntroductionThe present science curriculum includes a range of student learning outcomes covering laboratory and experimental scien

5、ce (MOE, 2007). Researchers and scholars had argued that the roles of experiments and practical work in schools should allow students to practice laboratory skills, learn the various investigative processes and acquire first hand experiences in dealing with materials and laboratory wares (Boud, Dunn

6、 and Hegarty-Hazel, 1986; Doran et al, 2002; Hegarty-Hazel, 1986; Josephsen, 2003; Woolnough, 1990).Besides these cognitive and psychomotor objectives of school laboratory courses, there are also suggestions that lessons should be made more attractive through more intellectually demanding courses an

7、d new teaching techniques that can motivate students to learn (Schmidt, 2000).This paper discusses a well-documented reflective learning strategy - the use of questions posed by students to help them extend their learning beyond curricular requirements (Chin and Chia, 2004; Walsh and Sattes, 2005).S

8、pecifically, it discusses the use of what if questions posed by students (Fogarty, 1994). Students are introduced to a distillation set up and then asked to pose what if questions about it. Their questions and the corresponding peer responses provide teachers with a good insight on how students cont

9、ribute to knowledge building through self-created learning opportunities.The entire experience may also help to create a classroom teaching-learning culture in which the teacher takes on the role of the advanced learner among novice learners. Conducting the lessonTraditionally a lesson on experiment

10、al science would commence with teacher talk, student evaluation and then possibly, a confirmatory experimental experience in the laboratory.Inquiry-based lessons may tweak the lesson structure a bit, with the teacher starting a learning task by asking a question.For example, “If you are stranded in

11、the open sea on a small boat, how would you go about making some fresh water to drink from the sea water around you?(Assuming you have the essential laboratory wares with you.)”The teacher may then follow up by facilitating a class discussion and end with the teacher summarizing and contextualizing

12、the discussion to fit the curricular requirements.Mortimer and Scott (2003) in their book, Making Meaning in Secondary School Science, suggested that students should engage in some form of dialogic activity if they are to develop an understanding of a science topic.In this respect, classroom talk, l

13、earning and meaning making would not make strange bedfellows but are essential features in the science classroom that would ensure students gain some impactful learning experiences.The lesson, which the present discussion is based on, involved both the traditional classroom lesson delivery and the e

14、ngagement of student dialogic process. It was conducted for a group of ten secondary three express students (equivalent to grade 8).The students, four girls and six boys, were selected by their Chemistry teacher to attend a remedial lesson on the topic of “Separation Techniques”.They came from two d

15、ifferent classes taught by the same teacher.The separation technique to be revised in the 40-minute lesson was on “Simple Distillation”.The author of this paper was requested by their teacher to teach this remedial lesson.The author (referred to as the remedial teacher in this paper) is also a quali

16、fied and experienced school science teacher of over 16 years. The proceedings of the lesson are summarized in Table 1.ApproximateTime frameLearning/teaching eventsPedagogical approach10 minutes- Introduction - Importance of separation techniques in chemistry- Example of a technique: Simple Distillat

17、ionTeacher talk 10 minutes- Activity: Students to pose questions- First attempt: Invitation to verbalise the questions (nostudents volunteered)- Second attempt: Invitation to write down the questions starting with the words “What if.” (Students were observed to be actively on task.)Reflective learni

18、ng strategy: Use of “what if” questions to get students to observe the learning task and generate responses (in this case posed questions)20 minutes- Activity: Teacher-facilitated the discussion on the what if questions posed and writtenby the students on slips of paper.- The slips of paper were col

19、lected and each students written questions were projected on visualiser and openly discussed by the students with comments and evaluative remarks made by the teacher.Students were instructed not to write their names on the paper.Reflective learning strategy: students engaged in meaning making (that

20、is, attempting to answer, critique and perhaps re-phrase the questions so that some relationships can be established among the ideas generated).5 minutes- Summary: teacher summarised students responses to the learning tasks- Conclusion: teacher concluded lesson with a review of the distillation meth

21、odTeacher talkTable 1: Lesson ProceedingsAfter the formal greetings and a simple self-introduction, the remedial teacher proceeded to explain the importance of separation techniques in chemistry. He cited simple distillation as an important technique that allows us to obtain a pure solvent or liquid

22、 from a contaminated liquid sample (a solution or a suspension).A fully labelled diagram of the apparatus set up for simple distillation was projected on the screen with the help of a visualiser (Figure 1).Referring to the diagram on the screen, the remedial teacher then proceeded to explain how the

23、 simple distillation apparatus works.The students were attentive and some were busy taking notes. This segment of the lesson lasted about ten minutes and was totally delivered by teacher-talk.Figure 1.Diagram of a simple distillation set up for distilling seawater.At this juncture, students were inv

24、ited to verbally ask any question about the apparatus set up.There was a short pause with no response from the students.The remedial teacher then requested that they pen their questions on blank pieces of paper.Again, there were some “thoughtful” actions (for examples, a boy had his chin propped by

25、his hand on the table and a few girls showed contorted eyebrows, all presumably deep in their thoughts).Most of them stared blankly at the diagram projected on the screen. Again, no one wrote anything.The remedial teacher then wrote the following words on the whiteboard “What if” and instructed stud

26、ents to begin posing their questions with these two words.He also added that they could ask anything about the apparatus set up, including the materials, products, reaction conditions or anything that interest them, so long as it was something related to the simple distillation process or apparatus

27、set up. They could ask questions that they know the answers, or questions that they do not know the answers.No examples were given to the students other than these instructions.It was observed that students began to pen their thoughts, writing down the questions and raising their heads periodically

28、to refer to the diagram shown on the screen.It took about ten minutes before most of them became exhausted of ideas and a few started to curiously peek into their neighbours work.The remedial teacher then collected the papers and began to flash them one by one on the visualiser.For each students que

29、stions presented, the remedial teacher facilitated an almost spontaneous response from the floor.Students were observed to be chatty while a few showed amusements at their peers questions.There was a lively contribution to the possibilities raised by the questions, including difficult and unfamiliar

30、 situations arising from questions like “What if there is no condenser there?” and “What if the Bunsen burner was replaced by a candle?” (Figure 2)Figure 2.“What if.” questions can surface unfamiliar experimental situationsThe “what if” questions and peer responsesThe activity generated a list of 26

31、 questions from the ten students (Table 2).These questions can be broadly classified into 11 different types of “What if” questions pertaining to the topic on simple distillation of seawater. ConditionsBroad Questions AskedFrequencyAMissing materials1. “What if there was no boiling stones in the fla

32、sk?”6BChange in set up of apparatus (including missing pieces)2.“What if the positions of the water inlet and outlet of the condenser were switched?23 “What if there were no thermometer in the set up?”14. “What if there were no condenser?”5CChange in choice of apparatus or materials5.“What if candle

33、(s) was/were used in place of the Bunsen burner?26.“What if hot water was used in the condenser instead of cold water?”17.“What if the flask is made up of a different material (other than pyrex glass)?”18.“What if there are other particles in the seawater?”1DChange in physical or environmental condi

34、tions9. “What if the room conditions were changed (higher or lower than standard)?”410.“What if a smaller (Bunsen) flame was used?”2EUnexpected experimental results11.“What if the water distillate was tested to be impure?”1Total number of “What if” questions generated =26Table 2: Breakdown and frequ

35、ency of the types of “What if” questions posed by students.(For the actual questions posed by students, please see Annex A)Unfortunately, the lively discussion during the presentation of the students “What if.” questions was not documented on paper on the spot or recorded in any media form.However,

36、some typical examples of peer responses to the posed questions are summarized in Table 3.A few of the peer responses may not be technically sound and some may be incorrect.It is important to have these misconceptions addressed immediately, and on the spot, by the teacher.This was done each time the

37、teacher identified a misconception during the discussion.Table 3 also shows some examples of students misconceptions identified from their posed questions and peer responses. “What if.” questions and typical peer responses1. “What if there was no boiling stones in the flask?”Typical peer responses:

38、a. “There will be no boiling in the water.” (Misconception)b. “Boiling will spill out of the flask.” (Possible, especially if “bumping” occurs and may cause the boiling liquid to spill out through the thermometer adaptor.)What could happen and why it happened:The boiling stones provide jagged surfac

39、es for dissolved air to form small air Bubbles.This will prevent the formation of a big air bubble at the bottom of the flask which would attempt to “break free”, hence the “bumping” phenomenon.2.“What if the positions of the water inlet and outlet of the condenser were switched? Typical peer respon

40、ses: a. “There will not be any liquid collected.” (Misconception) b. “There will be less liquid collected.” (Actual result)What could happen and why it happened:The direction of condensing medium (cold water) in the jacket of the condenser should be opposing the direction of the hot vapour entering

41、the condenser through the tube. This way, there will always be a maximal temperature gradient between the hot vapour and cold condensing medium, resulting in a large amount of vapour condensing into the distillate.By switching their positions, the temperature gradient will be greatly reduced and som

42、ewhere midway or so in the condenser, the temperature difference between the vapour and the medium may not be significant enough to continue a good condensation process, hence the amount of distillate obtained will be reduced.3 “What if there were no thermometer in the set up?”Typical peer responses

43、: a. “I cannot do the experiment, because I cannot read the temperature.” (Fair enough, but distillation can still continue without the thermometer in place.) b. “The distillation will be slower.” (Misconception)What could happen and why it happened:The thermometer serves only as a monitoring instru

44、ment in this apparatus set up.It does not contribute to the distillation process.The distillation will still continue as usual, at the same rate, with or without the thermometer.Table 3: Typical peer responses (verbal) to “What if” questions posed by students DiscussionThe teacher-talk section laste

45、d about ten minutes.Students took about another ten minutes to think about how to pose and write down the questions.This involved closely studying the diagram on the projector screen, generating possibilities on how the questions may be written, and making sense of the questions and possible respons

46、es if they know the answers.This was what one student did she provided answers to her own questions.(See Annex A, last example)The next twenty minutes were spent on facilitating peer responses to the questions.It is interesting to note that the students came from two classes and may not have known e

47、ach other well.Although this is may be an assumption, what is amazing was that they were able to warm up to a total stranger, the remedial teacher, in just a couple of minutes.They were chatty and fully engrossed in contributing to possible answers to their peers questions.There was laughter, an occ

48、asional argument and of course, delightful comments like “Ah, we didnt know that!” or “Oh, now I see!” (for example, when the teacher commented that theoretically, replacing the Bunsen burner with a candle would still lead to pure water being collected as the distillate, but in practice, this would be a slower and a less efficient process).They also expressed surprise that the thermometer is not an essential piece of apparatus in the set up.The entire classroom learning experience threw up several interesting and noteworthy teaching-learning issues for science teachers.(1)