协同通信与AF和DF中继协议.doc

《协同通信与AF和DF中继协议.doc》由会员分享，可在线阅读，更多相关《协同通信与AF和DF中继协议.doc（24页珍藏版）》请在淘文阁 - 分享文档赚钱的网站上搜索。

1、精品文档，仅供学习与交流，如有侵权请联系网站删除AbstractNowadays, there is a trend for communication system that the whole network system is becoming dynamic so that there are always having devices should be embedded and removed. Conventional wired communication, due to the complexity of cabling, does not adapt to the mode

2、rn communication system. Wireless technique has been used widely because devices can be connected by electromagnetism wave without cabling. However, low transmitting reliablity because of inter-interference between electromagnetism waves is the key problem of wireless communication. Based on this, t

3、his thesis investigates one of the technique called cooperative communication and it cooperative protocols.Cooperative communication is a virtual multiple-input multiple-output(MIMO) system. To increase the reliability of signal transmitted without increasing the amount of communication devices, thi

4、s technology tries to make each antennas have one or more partners that assist them to transmit the signal. In wireless network, the devices not only transmit their own signal but also assist their “partner” to transmit their signal for saving the cost of installation of additional antennas at both

5、receiver and senderIn this thesis, we focus on introducing three main protocols in cooperative communication: Amplify-and Forward(AF), Decode-and-Forward(DF) and Coded Cooperation(CC). The performance and mathematical equations of AF and DF are analysed , and then MATLAB programs were created to sim

6、ulate the performance of these two protocols. About the three protocols, the main procedures are also introduced. The performance comparison for AF and DF in different signal-to-noise(SNR) are demonstrated. The result presents that the DF protocols has better performance than AF. Finally, some recom

7、mendations and future work are mentioned at the end of the thesis.【精品文档】第 24 页Table of ContentsAbstractTable of containsList of figuresList of abbreviations and Symbols1 Introduction.91.1 Background.91.2 Objectives.91.3 Approaches.91.4 Thesis outline.102 Literature Review.122.1 Overview.122.2 Spatia

8、l diversity technology.132.3 Basic Model for Wireless.132.3.1 SISO system.132.3.2 MIMO system.142.3.3 Cooperative model.142.4 Cooperative schemes.152.4.1 Amplify-and-forward method.162.4.2 Decode-and-forward method.162.4.3 Coded cooperation.173 Simulation and Analyses of AF.213.1 Overview.213.2 Maxi

9、mum likelihood method.213.3 Simulation and Analysis.213.3.1 The whole procedure and analysis.213.3.2 Simulation.243.4 Summary.264 Simulation and Analysis of DF.274.1 Overview.274.2 Quantization method.274.3 Convolutional Code and Viterbi decode.274.3.1 Convolutional code.284.3.2 Viterbi decode.284.4

10、 Simulation and analysis.284.4.1 The whole procedure and analysis.294.4.2 Simulation.304.5 Performance comparison between AF and DF .314.6 Main challenges.324.7 Summary.335 Conclusions and future work.345.1 Conclusion.345.2 Prospect.345.3 Future work.35Reference.36Appendix A Thesis specification.37A

11、ppendix B Logbook Summary Signature.40Appendix C MATLAB programs.41C.1 Amplify-and-Forward Protocol.41C.2 Decode-and Forward protocol.42C.3 Rayleigh channel.45List of FiguresFigure 2.1 virtual MIMO system .13Figure 2.2 Cooperative communication .14Figure 2.3 MIMO system.15Figure 2.4 Cooperative mode

12、l.16Figure 2.5 Relay amplify model.17Figure 2.6 Decoded and forward model.18Figure 2.7 Coded cooperative model.19Figure 2.8 Coded cooperation data allocation.20Figure 2.9 Four cases in coded cooperative.20Figure 3.1 first time slot in AF method.23Figure 3.2 Second time slot in AF method .24Figure 3.

13、3 AF protocol BER diagram .26Figure 4.1 (n,k,m) convolutional encoder.29Figure 4.2 first time slot of DF.30Figure 4.3 Second time slot.30Figure 4.4 DF protocol BER diagram.32Figure 4.5 DF whole procedures.32Figure 4.6 performance compared between AF and DF.33List of Abbreviations and SymbolsMIMOMult

14、iple input multiple outputSISOSingle input single outputAFAmplify-and-ForwardDFDecode-and-ForwardCCCoded CooperationBERBit error rateQPSKQuadrature phase-shift keyingi.i.dindependently and identically distributionMLMaximum likelihoodSNRSignal noise-ratio1 Introduction1.1 BackgroundWireless communica

15、tion is, recently, the fastest improving segment and most widely used way of the communication industry. For utilizing the broadcast property of electromagnetism wave, the information can be transmitted in wireless environment, which saves much cost for cabling and makes the change of network struct

16、ure easily. On the other hand, as wireless technique is used more widely, there are also many problems appearing. For example, the wireless signal can be affected a lot by the transmitting medium and interfered with other signal and the destination will receive not only the direct wave but also some

17、 extra waves. These sorts of wave signal will generate and form the received signal at the destination, which will result in sharply differing with the original signal so that decreases the quality of signal and reliability. This is called multipath fading11. To solve these problems, cooperative com

18、munication is one of the methods.Cooperative communication technique is a method based on MIMO(multiple-input multiple-output)system. MIMO system is a model that installing more than one antennas in both the sender and receiver, which achieve one signal is transmitted by different channels. In pract

19、ical, due to the limitation of size, power waste and hardware, it is hard to install a lot of antennas in one communication device so that MIMO technique is hard to utilize in practical directly. Thus, cooperative communication is a model that builds a virtual MIMO system among existing antennas ins

20、tead of building additional antennas but achieves the gain of MIMO system8.Compared with traditional transmitting method, cooperative communication builds a cooperative work relationship between each antenna which means each antenna will have a helper to assist them to transmit signal and these help

21、er antennas will take some measures to optimize the quality of signal. Therefore, at the destination, lots of signals will be received so that receiver can have gain of diversity. Some protocols describe what functions these antennas apply for optimizing signal. In this report, some explanations and

22、 literature reviews focused on amplify and forward protocol, decoded and forward protocol and coded cooperative protocol are demonstrated. Otherwise, simulation result for amplify and forward and decoded and forward protocol is made. 1.2 ObjectivesThe purpose of this project is to analyse the advant

23、ages of cooperative communication by analysis of three main cooperative protocols. In this half year, this project can have a conclusion about three objectives:1. Trying to understand the concept of cooperative communication and its working system models. Research for how the signal delivered throug

24、h nodes. 2. Finding the three cooperative protocols that antennas obeyAF ( amplifyand- forward), DF (decode- and- forward) and CC (coded cooperation) protocols and how they works.3. Use the MATLAB to simulate the performance of AF and DF and do a comparison about them.1.3 ApproachesFirstly, analyzin

25、g the concept of cooperative communication and finding the fundamental protocols about it. Secondly, finding the important described equations and the used coefficients. Finally, use MATLAB to simulate the procedures of AF and DF and try to get the BER( bit error rate)-SNR(signal-Noise ratio) diagra

26、m and compare the their performance.1.4 Thesis outlineThis report includes five parts: first part introduce the background of cooperative communication. Second part explains several literature reviews about wireless, diversity technology, MIMO and cooperative protocols. Third and forth parts demonst

27、rate the simulation about AF and DF and get the result diagram. Additional, the forth part also includes the performance comparison between AF and DF. Last part makes a conclusion and the future work about the project.2 Literature Review2.1 OverviewTo overcome the lack of multiple antennas limited b

28、y size or hardware complexity, cooperative communication is proposed. Cooperative communication can be understood a virtual multiple input multiple output(MIMO) system between source and destination. In another words, the cooperative communication build a cooperative relationship among existing ante

29、nnas. For utilizing the broadcast property of electromagnetism wave, not only the destination, there are also some other antennas receive the source signal. Instead of discarding this signal, this relationship asks these antennas to take some measures to process this signal and retransmit it to the

30、appointed destination. Figure 2.1 virtual MIMO systemTo decrease the bit error rate and recover the source signal well, there are three common protocols for the helper antennas applying: amplify and forward(AF) protocol, decoded and forward (DF) protocol and coded cooperative(CC) protocol. Figure 2.

31、2 Cooperative communication 2.2 Spatial diversity technologyCooperative communication utilizes the spatial diversity technology. Diversity is an idea that transmitting a signal through many independent channels, it is described in 1. When source sends one signal in different independent channels, the destination will receive many formats about this signal. In this way, it can increase the signal-to-noise ratio(SNR) at the receiver which result in recovering the source signal better. There are three common diversity te