服装QC验货评语(doc11).docx

《服装QC验货评语(doc11).docx》由会员分享，可在线阅读，更多相关《服装QC验货评语(doc11).docx（10页珍藏版）》请在淘文阁 - 分享文档赚钱的网站上搜索。

1、服装QC验货评语collar領Unbalance collar 領不平衡Asymmetric collar領位不對稱Uneven collar width 左右領闊不一致Uneven neckline左右領圈不一致Uneven collar point領尖不對稱Uneven lapel shapes左右前領咀形狀不一樣Too much easing at C.F. neckline 前領口溶位太多(有太多溶位於前中領窩) 中国最庞大的下载资料库Collar too tight at CB 後領中太緊Collar band is twisting領座扭曲不平順Fullness at front

2、collar and lapel領及前領咀不平順Neckline is not smooth領圈不圓順Neck setting not smooth領子裝得不平順High & low back neck後領圈有高低Edge of front opening is crooked前門領邊不直Front opening not straight前門領邊不直Front facing is exposed at bottom hem前門領貼在下擺處外露Front opening facing is shorter than body前門領貼短於大身Neck was stretched領圈拉松Too m

3、uch tie on front collar前領處有豁口Sleeve & Armhole袖&夾Puckering at left/right armhole 左右夾圈有溶位不平伏.Too loose at right armhole, uneven for left/right armhole 右夾圈有拉松, 左右夾圈不相稱.Sleeve running to back(衣袖走後) / Sleeve running to front(衣袖走前) 操兵袖Too loose at front sleeve seam 前袖骨拉松Too tight at back sleeve seam 後袖骨過緊

4、.Poor cuff setting卡夫裝得不好Sleeve placket is not set well袖叉裝得不好Underarm seam was stretched袖底縫被拉松Armhole setting not smooth袖孔不圓順Ease on sleeve cap is uneven袖頂縮拱不均勻Front/back前後幅Hiking at front, CF facing too short 吊襟Hiking at back, lining too short 吊裡Curve at CF zip(too much fullness at CF zip) 前中拉鏈溶位太多C

5、urve at CF zipper because of no easing of zipper. 前中拉鏈無溶位(引致紐曲)Hiking at back / Hiking at front 後幅吊起 / 前幅吊起Front panel is bigger than under panel(lining)前幅底幅細面幅松Lining too big, too short, too small, too long 裡布太大, 太短, 太小, 太長Grain lines are not match at front & back panel 前後幅布紋不相稱Front length uneven左

6、右前長不一致Too loose at shell, Too loose at back/lining, turn insider out 底松, 面鬆, 向外反Pocket 袋 High-low pocket高低袋Both pocket set uneven左右口袋裝得高低不一Pocket not smooth / squared袋不平服/不夠正方Pocket flap not centered over pocket袋蓋不正中Both pocket shapes are uneven左右口袋形狀不一致Bottom part of pocket is sagging口袋下部下垂Pocket f

7、lap is misplaced袋邊位置不對Pocket is misplaced口袋位置不對Pocket is smiling袋口開得不吻合Pocket opening is fray袋口有毛口Pocket shape distorted口袋變形Pocket size and shape is not follow sample exactly口袋的尺寸及形狀未按照實樣做Pocket welt is uneven上下袋唇不均勻Poor pocket setting口袋裝得不好Binding拉捆 Piping is uneven捆邊不均勻Piping is twisting and not s

8、mooth捆邊扭曲不平順Pleats縮褶 Uneven shirring at back waist seam後腰縮碎褶不均勻。Shirring碎褶Elastic shirring is uneven橡筋縮拱不均勻Both side pleats not balance左右褶位不一致Darts placement is not follow sample exactly褶位未按照實樣做Pleats is misplaced褶位不對Shirring / Gathering 縮褶Pleated 生褶Darts 死褶Beading & embroidery釘珠&繡花 Beads stitching

9、are not secure珠子未釘牢Embroidery stitching is too tight 繡花線太緊Embroidery stitching too loose繡花線太松SHADING DEFECTS 色差問題 1)Color shading色差2)Color shading within one garment.同一件衣服內有色差。3)Color shading between trims and body.配件與衫身之間有色差。4)Shade differs from approved standard.顏色與批核色版不同。5)Shading caused by poor

10、color interlining matching. 紙朴顏色不配合, 引致色差。ACCESSORIES輔料問題 1)Missing button / label / badge 漏鈕 / 漏嘜頭 / 漏章2)Button position not well match buttonhole. 鈕與鈕門位置欠配合3)Button inside out鈕的底面倒置4)Button marking not removed.點鈕筆痕沒有清除5)Damaged button/buttonhole鈕爛/爛鈕門6)Rusted stud 工字鈕生銹7)Paint peel off on stud工字鈕顏

11、色脫落8)Button and buttonhole not aligned cause bulge.鈕及鈕門位置不配合, 引致谷起9)Buttonhole too small to allow button to pass through.鈕門太細, 鈕不能順利通過10) Uncut buttonhole / partially cut buttonhole鈕門未幵 / 鈕門未開盡11) Ragged edges at buttonhole鈕門紗線不清12) Broken buttonhole stitches鈕門斷線13) Button thread easily pulled out.

12、釘鈕線容易拉脫14) Snap / rivet easily pulled off.吸鈕、撞鈕容易拉脫15) Buttonhole is not match button size鈕洞尺寸與鈕扣大小不相配16) Button misplaced鈕扣位置不對17) Buttonhole misplaced鈕洞位置不對18) Button is not sewing security鈕扣未釘牢19) Button is sewn too tight鈕扣釘得太緊20) Buttonhole is fray鈕洞有毛口21) Key buttonhole density is too loose 鳳眼鈕

13、洞的車縫線步太疏22) Key buttonhole is misplaced鳳眼鈕洞位置不對23) Snap misplaced揿鈕位置不對24) Snap tape is misplaced撳鈕扁帶位置不對25) Snap tape setting not well撳鈕扁帶裝得不好26) There is bubble on buttonhole area鈕洞周圍有氣泡27) Hood and bar is misplaced裙扣位置不對28) Hole at zip top / end拉鏈頂 / 尾有洞29) Zipper setting is twisting拉鏈裝得扭曲30) Sho

14、ulder pad not attach to garment security 肩棉未釘牢31) Shoulder pad not cover well肩棉未包好32) Velcro is misplaced么朮貼位置不對33) Waistband belt is not set straight腰耳裝得不直34) Waistband belt length and width are uneven腰耳的長、寬不一致35) Incomplete adhesive on interlining.黏朴未完全黏好36) Strike through of adhesive on interlini

15、ng.黏朴膠露面37) Strike back of adhesive on interlining.黏朴脫落38) Blistering occurred on interlining.黏朴起泡39) Insecure shoulder pad attached. 肩棉釘縫不穩40) Label placement incorrect.嘜頭位置不正確41) Care label content not as specified.成份嘜內容不符合要求42) Main label and size/content label are set too closed 主嘜與尺碼成份嘜裝得太靠近43)

16、 Main label setting is misplace釘主嘜不井齊44) Wrong care label sewn on garment.成份嘜車錯位置45) Label not properly secured.嘜頭車縫不穩46) Label sewn beyond label edge.嘜頭車縫太入47) Label sewing seam uneven / puckered. 嘜頭車縫不平均或起皺48) Wrong accessories used.用錯輔料Button out of line.鈕位不成直線STITCHING AND SEAMS 線步和骨位 1)Raw edge

17、散口2)Raw edges爆口3)Untrimmed thread ends線頭未剪4)Skipped stitches跳線5)Exposed stitching 露線6)Broken stitches斷線7)Run-off stitches間線落坑8)Crooked stitches線步彎曲9)Poor join stitching駁線欠佳10)Unsightly over-lapping stitches 駁線不良11)Stitches too loose線步太松12)Stitches too tight線步太緊13)Distorted stitches車線不直14)Broken seam

18、s縫線爆幵15)Expose stitch落坑線外露16)Inconsistent stitching線步不一致17)Uneven width on double stitching 雙線闊窄不均18)Uneven stitching density / tension線步密度 / 鬆緊度不平均19)1/4 top stitch not even1/4面線有寬窄20)Expose safety stitch保險線外露21)Inseam is uneven內縫線不井齊22)Merrow stitch density is too big撥邊線步太疏23)Overlap stitch is not

19、 well反縫的接線不好24)Top & under stitch tension not match底面線力不相符25)Uneven merrow seam內撥邊線彎曲不直26)Missing reinforcement stitches漏車加固線步27)Row of stitching missing top stitch漏車一行線平車線28)Stitch count less than standard線步較標準少29)All top stitch is uneven所有的面線都不均勻30)Blind stitch is broken筒針有斷線現象31)Blind stitch is w

20、avy筒線彎曲不直32)Shoulder seam not smooth小肩縫彎曲不直33)Uneven folded width at bottom sweep 1/2hemming.折車1/2腳圍闊窄34)Blind stitching visible挑腳線露面35)Incomplete seam stitching線步不到尾36)Uneven for hem closure stitching, uneven stitch at hem 下腳車線不直37)Exposed waistband running stitches 裙頭/褲頭見坑線38)Not straight at front

21、 fly 褲鈕牌車線不順直39)Not straight at back yoke 後擔干車線不直, 紐曲40)Skipping stitches, looping stitches 跳線, 車線太鬆起耳仔41)Seam allowance, sewing thread too tight 子口補間線, 線太緊起豆角42)Pleated seam骨位打褶43)Puckered seam骨位起皺44)Open seam 爆骨45)Burst seam 爆骨46)Under seam visible底骨露面47) Waviness on seams骨位起波浪48) Twisted seams /

22、Seam rolling 扭骨49)Twisting at side seam, Wavy at side seam 側骨紐, 不順直.50)Seam closures uneven骨位結尾不平均51) Missing bar-tack漏打棗52) Seam not properly secured骨位不牢固53) Fullness on seams骨位太谷, 不平伏54)Seam not fully opened before stitching. 骨位未完全撥開間線55)Cracked seam骨位拉時有響聲(引致斷線)56)Too loose at princess seam 前公主骨拉松起泡57)Puckering at back princess seam 後公主骨溶位太多, 起皺/起豆角58)Too tight or too loose at side seam. 側骨車線太緊或太鬆59)Too loose at CF / CB seam 前中/後中骨太松60)Too loose at shoulder seam, unbalance of front & back panel at shoulder seam 肩骨拉松(要落定位)61)Too flat at shoulder seam, too slant of shoulder seam 肩骨太平/太斜