雅思图表作文_A类小作文_范文.doc
《雅思图表作文_A类小作文_范文.doc》由会员分享,可在线阅读,更多相关《雅思图表作文_A类小作文_范文.doc(5页珍藏版)》请在淘文阁 - 分享文档赚钱的网站上搜索。
1、1. You should spend about 20 minutes on this task.The graph and table below give information about water use worldwide and water consumption in two different countries.Summarise the information by selecting and reporting the main features, and make comparisons where relevant.Write at least 150 words
2、1.png (6.19 KB)2010-6-17 10:59model answer:The graph shows how the amount of water used worldwide changed between 1900 and 2000.Throughout the century, the largest quantity of water was used for agricultural Purposes, and this increased dramatically from about 500 km to around 3,000 km in the year 2
3、000. Water used in the industrial and domestic sectors also increased, but consumption was minimal until mid-century. From 1950 onwards, industrial use grew steadily to just over 1,000 km, while domestic use rose more slowly to only 300 km, both far below the levels of consumption by agriculture.The
4、 table illustrates the differences in agriculture consumption in some areas of the world by contrasting the amount of irrigated land in Brazil (26,500 km) with that in the D.R.C. (100 km). This means that a huge amount of water is used in agriculture in Brazil, and this is reflected in the figures f
5、or water consumption per person: 359 m compared with only 8 m in the Congo. With a population of 176 million, the figures for Brazil indicate how high agriculture water consumption can be in some countries.(180 words)You should spend about 20 minutes on this task.2. The flowchart illustrates the pro
6、duction of coloured plastic paper clips in a small factory.Write a report for a university tutor describing the production process.Write at least 150 words.model answer:There are four main stages in the production of plastic paper clips from this small factory. Two of these stages involve actual pre
7、paration of the clips, while the other two consist of quality control before the clips are sent out from the factory to the retailers to be sold to the public.To begin with, molten plastic is poured into three different moulds depending on the colour required; the colours are red, blue and yellow. O
8、nce these clips emerge from the moulds a quality control machine checks them for strength. Unsatisfactory clips are rejected. In the third stage in the process the clips are stored by hand into two groups, mixed and single colours. When this stage is complete the groups are checked a second time to
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 雅思 图表 作文 _A 范文
限制150内