2×660MW超超临界燃煤空冷机组新建工程100%容量锅炉给水泵技术协议书.doc





《2×660MW超超临界燃煤空冷机组新建工程100%容量锅炉给水泵技术协议书.doc》由会员分享,可在线阅读,更多相关《2×660MW超超临界燃煤空冷机组新建工程100%容量锅炉给水泵技术协议书.doc(104页珍藏版)》请在淘文阁 - 分享文档赚钱的网站上搜索。
1、国电建投内蒙古能源有限公司布连电厂一期2660MW超超临界燃煤空冷机组新建工程Bulian Power Plant 2660MW Extra-supercritical Coal-fired Air-colded Unit New Project100%容量锅炉给水泵100% Capacity Boiler Feed Water Pump技术协议 目 录附件1 技术规范APPENDIX 1 TECHNICAL SPECIFICATION11 总则General12 工程概况Project outline43 设计和运行条件Design and Operation Condition114 技术
2、条件Technical Conditions225 质量保证、试验、监造及验收Quality guaranty, Testing, Supervision (Inspection)and Performance Acceptance466 包装、运输、装卸 Package , Transportation, loading&unloading527 设计与供货界限及接口规则 Design and supply scope & Interface regulations548 锅炉给水泵热控技术要求Technical requirement of instrumentation control
3、on boiler feedwater pump57附件2 供货范围APPENDIX 2 SCOPE OF SUPPLY671 一般要求General Requirements672 供货范围Scope of Supply67附件3 技术资料及交付进度APPENDIX 3 TECHNICAL DOCUMENTATION AND SUBMISSION SCHEDULE761 一般要求General Requirements762 资料提交的基本要求Basic Rrequirements of Document Submission78附件4 交货进度APPENDIX 4 DELIVERY SCH
4、EDULE82附件5 监造、检验和性能验收试验APPENDIX 5 SUPERVISION ,INSPECTION AND APPROVAL TEST831 概述General Description832 工厂检验Workshop Inspection833. 设备监造Equipment Supervision854 性能验收试验performance acceptance test89附件6 技术服务与联络APPENDIX6 TECHNICAL SERVICE AND DESIGN LIAISON901卖方现场技术服务The technical service of the seller
5、on site902 培训Training923 设计联络会Design Liaison93附件7 分包与外购96附件8 大部件情况APPENDIX 8 OVERSIZE INFORMATION98 102附件1 技术规范APPENDIX 1 TECHNICAL SPECIFICATION1 总则General1.1 本技术协议适用于国电建投内蒙古能源有限公司布连电厂一期工程2660MW国产超超临界燃煤空冷机组的锅炉给水泵组设备,范围为两台机组所配套2台100%容量汽动给水泵、前置泵和本工程两台机组共用的1台电动启动给水泵组,汽动给水泵及其前置泵采用同轴驱动方案。本技术协议提出了设备的功能设计
6、、结构、性能、安装和试验等方面的技术要求。This specification is only applicable for the boiler feed water pumpsets for Bulian Power Plant Phase I 2660MW domestic extra-supercritical coal-fired air colded power generation project. The scope includes two sets of 100% capacity turbine driven boiler feed water pumps and its
7、 booster pumps for the two Units, and one set of motor driven start-up feed water pumpset shared by the two Units. The turbine driven feed water pump and its booster pumpsets will be driven by the same turbine. This specification defines the technical requirements for the function design, structure,
8、 performance, installation and test of the supplied equipment.1.2 买方在本技术文件中提出了最低限度的技术要求,并未规定所有的技术要求和适用的标准,卖方提供一套满足本技术协议和所列标准要求的高质量产品及其相应服务。The technical requirements specified in this specification shall be interpreted as a minimum requirement; it does not specify all technical requirements and appl
9、icable standards. The Seller shall ensure to provide high quality products to satisfy this specification and international or national standards.1.3 卖方在签订合同后3月内,提出合同设备的设计、制造、检验/试验、装配、安装、验收、试验、运行和维护等方面的技术参考资料给买方,并同时提供供货清单,正式资料按工程进度要求提供。Technical documents for reference to Buyer, on design, produce, i
10、nspection and approval test, arrangement, installation, acceptance, testing ,operation and maintenance for the equipment, shall be submitted to buyer within 3 month after signed the contract with supply list. The certified documents shall be submitted following the progress of works. 1.4 本工程采用KKS标识系
11、统。卖方提供的技术资料(包括图纸)和设备标识必须有KKS编码。编码规则由设计院提出,在设计联络会上讨论确定。The project adopts KKS coding system. there shall be KKS coding on the submitted document(including drawings) and equipment labels. Coding rule shall be supplied by the institute, certified on the liaison meeting.1.5 专利涉及到全部费用均已包含在合同价中,买方不承担有关设备专
12、利的一切责任。以合同条款为准。All cost on patent has been included in the contract, the buyer shall not take on any responsibility on related equipment patent. Contract clause will be govern.1.6 卖方在设备设计、制造、试验等过程中所涉及的各项规程,规范和标准必须遵循现行最新版本的标准。All related rules,criterion and standards in design,produce and testing sha
13、ll meet the lastest standards.1.7 本技术协议所引用的标准若与卖方所执行的标准发生矛盾时,按较严格的标准执行。If there is any deviation between the standard listed in this spacification and the standard used by the seller, the higher standands shall be used.1.8 本技术协议经买、卖双方共同确认和签字后作为订货合同的技术附件,与订货合同正文具有同等效力。This technical agreement shall b
14、e technical appendix of contract after confirmed and signed by both sides, and it shall has the same effect as the contract.1.9 卖方对锅炉给水泵组供货的成套系统设备(含辅助系统与设备)负有全责,即包括分包(或采购)的产品。买方有权参加分包、外购设备的招标和技术谈判,但技术上由卖方负责归口、协调。The Seller shall be full responsible for the completed system and equipment in his suppl
15、y scope (including auxiliary system and equipment), that includes subcontracted (or outsourced) products. For the subcontracted and outsourced equipment, the Buyer reserves the right to attend bidding and technical negotiation meeting; however it shall not release the Seller from his responsibility
16、of technical interface and co-ordination.1.10 在技术协议签定后,买方有权因规范、标准、规程发生变化而提出一些补充要求。The Buyer has the right to raise additional requirements due to changes of design specification, standards or regulations after technical agreement.1.11 本工程从基建期就开始全面推行NOSA安健环五星管理,卖方提供的设备必须满足NOSA安健环五星管理的要求。重点如下:The NOSA
17、 - Safety, Health and Environment management concept will be implemented from the construction stage for this project, the equipment supplied by the Seller shall complies with the NOSA requirements. The main points are as below:1.11.1电气设备颜色要符合国电集团公司和项目公司安全设施规范手册具体要求;The surface painting color of the
18、 electrical equipment shall meet the requirements of Safety Facility Specification Manual of China Guodian Corporation and the project company.1.11.2开关和控制柜的铭牌、编号、内部接线、布局、接线图、漏电保护器、门上的电力符号、锁具等均要按照NOSA安健环五星管理的要求制造安装,由买方在设计联络会上提供;The nameplate, tag number, internal wiring, layout, wiring diagram, volta
19、ge leakage protector, door electrical mark, lock for switch and control cabinet shall be manufactured and installed according to NOSA requirements, which will be provided by the Buyer at design liaison meeting.1.11.3设备阀门颜色、转向指示、开关标注、铭牌、护栏、防护罩、阀门配套锁定装置等均要按照NOSA安健环五星管理的要求制造安装,由买方在设计联络会上提供;The surface
20、painting color, rotation indication, switch mark, nameplate, guard and locking device for the Valve shall be manufactured and installed according to NOSA requirements, which will be provided by the Buyer at design liaison meeting.1.11.4管道色标、仪表刻度等均要按照NOSA安健环五星管理的要求制造安装,由买方在设计联络会上提供;The piping color,
21、instrument scaling shall be manufactured and installed according to NOSA requirements, which will be provided by the Buyer at design liaison meeting.1.11.5防护装置的具体要求如下:Requirments on protection device:1.11.5.1为所有的轴端安装防护装置,转动机械的防护罩包括转动机械的全部外露转动部分的防护罩,含转动机械的联轴器、机械密封等所有转动部分。Intalling protection device f
22、or every shaft end, the protection device of turning parts shall includes shield of all exposed turning parts, coupling with turning parts, mechnical seal.1.11.5.2为所有正常情况下能够伸手摸到运动部件安装防护装置或封闭,防护装置的设计要保证让维护人员便于拆除和进行更换,转动机械联轴器防护罩全部用钢板制作,防护罩边缘距转机固定部分大于5mm,小于8mm,防护罩底部封闭。The protection device shall be ins
23、talled at the part easy to touch in the normal operation.The design of protection device must easy backout and change for the site person.The protection shield shall be made by steel plate,the clearance between the edge of shield and the fixation shall be more than 5mm and less than 8mm, with the bo
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- 660 MW 临界 燃煤 机组 新建 工程 100 容量 锅炉 水泵 技术 协议书

限制150内